ASROCK K10N78-1394 Manuel d'utilisateur télécharger pdf (Page 31)

3131

FLOPPY1

Pin1

the red-striped side to Pin1

connect the black end

to the IDE devices

connect the blue end

to the motherboard

IDE1

PIN1

80-conductor ATA 66/100/133 cable

2.9 Onboard Headers and Connectors2.9 Onboard Headers and Connectors

2.9 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place

jumper caps over these headers and connectors. Placing jumper caps

over the headers and connectors will cause permanent damage of the

motherboard!

•

Floppy Connector

(33-pin FLOPPY1)

(see p.13/14, No. 23)

Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the

connector.

Primary IDE connector (Blue)

(39-pin IDE1, see p.13/14, No. 8)

Note: Please refer to the instruction of your IDE device vendor for the details.

Serial ATA II Connectors These six Serial ATAII

(SATAII_1 (PORT0): (SATAII) connectors support

see p.13/14, No. 16) SATA data cables for internal

(SATAII_2 (PORT1): storage devices. The current

see p.13/14, No. 13) SATAII interface allows up to

(SATAII_3 (PORT2): 3.0 Gb/s data transfer rate.

see p.13/14, No. 18)

(SATAII_4 (PORT3):

see p.13/14, No. 12)

(SATAII_5 (PORT4):

see p.13/14, No. 10)

(SATAII_6 (PORT5):

see p.13/14, No. 11)

For K10N78-1394, SATAII_6 (PORT5) connector can be used for inter-

nal storage device or be connected to eSATAII connector to support

eSATAII device. Please read “eSATAII Interface Introduction” on page 38

for details about eSATAII and eSATAII installation procedures.

SATAII_1 SATAII_3 SATAII_5

(PORT0) (PORT2) (PORT4)

SATAII_2 SATAII_4 SATAII_6

(PORT1) (PORT3) (PORT5)

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 71 72

Commentaires sur ces manuels

Pas de commentaire

ASROCK K10N78-1394 Manuel d'utilisateur Page 31

Commentaires sur ces manuels

Produits connexes et manuels pour Cartes mères ASROCK K10N78-1394