ASROCK 960GC-GS FX Manuel d'utilisateur télécharger pdf (Page 22)

2.7 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place

jumper caps over these headers and connectors. Placing jumper caps

over the headers and connectors will cause permanent damage of the

motherboard!

Serial ATA2 Connectors These six Serial ATA2 (SATA2)

(SATAII_1 (PORT 0):

connectors support SATA data

see p.12, No. 14)

cables for internal storage

(SATAII_2 (PORT 1):

devices. The current SATA2

see p.12, No. 15)

interface allows up to 3.0 Gb/s

(SATAII_3 (PORT 2):

data transfer rate.

see p.12, No. 12)

(SATAII_4 (PORT 3):

see p.12, No. 11)

(SATAII_5 (PORT 4):

see p.12, No. 10)

(SATAII_6 (PORT 5):

see p.12, No. 9)

Floppy Connector

(33-pin FLOPPY1)

(see p.12 No. 20)

Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the

connector.

the red-striped side to Pin1

connect the black end

to the IDE devices

connect the blue end

to the motherboard

80-conductor ATA 66/100/133 cable

Primary IDE connector

(39-pin IDE1, see p.12 No. 6)

Note: Please refer to the instruction of your IDE device vendor for the details.

SATAII_1 (PORT 0)

SATAII_2 (PORT 1)

SATAII_3 (PORT 2)

SATAII_4 (PORT 3)

SATAII_5 (PORT 4)

SATAII_6 (PORT 5)

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

ASROCK 960GC-GS FX Manuel d'utilisateur Page 22

Commentaires sur ces manuels

Produits connexes et manuels pour Cartes mères ASROCK 960GC-GS FX