ASROCK 960GC-GS FX Manuel d'utilisateur télécharger pdf (Page 28)

2.10 Driver Installation Guide

To install the drivers to your system, please insert the support CD to your optical

drive rst. Then, the drivers compatible to your system can be auto-detected and

listed on the support CD driver page. Please follow the order from up to bottom side

to install those required drivers. Therefore, the drivers you install can work properly.

2.11 Installing Windows

8 / 8 64-bit / 7 / 7 64-bit / Vista

Vista

64-bit / XP / XP 64-bit With RAID Functions

If you want to install Windows

8 / 8 64-bit / 7 / 7 64-bit / Vista

/ Vista

64-bit / XP

/ XP 64-bit on a RAID disk composed of 2 or more SATA / SATA2 HDDs with RAID

functions, please follow below procedures according to the OS you install.

2.11.1 Installing Windows

XP / XP 64-bit With RAID Functions

If you want to install Windows

XP / XP 64-bit on a RAID disk composed of 2 or

more SATA / SATA2 HDDs with RAID functions, please follow below steps.

STEP 1: Set up BIOS.

A. Enter BIOS SETUP UTILITY Advanced screen Storage Conguration.

B. Set the “SATA Operation Mode” option to [RAID].

STEP 2: Make a SATA / SATA2 Driver Diskette.

A. Insert the Support CD into your optical drive to boot your system.

B. During POST at the beginning of system boot-up, press <F11> key, and

then a window for boot devices selection appears. Please select CD-ROM as

the boot device.

C. When you see the message on the screen, “Generate Serial ATA driver diskette

[YN]?”, press <Y>.

D. Then you will see these messages,

Please insert a diskette into the oppy drive.

WARNING! Formatting the oppy diskette will

lose ALL data in it!

Start to format and copy les [YN]?

Please insert a oppy diskette into the oppy drive, and press any key.

E. The system will start to format the oppy diskette and copy SATA / SATA2 drivers

into the oppy diskette.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 51 52

Pas de commentaire

ASROCK 960GC-GS FX Manuel d'utilisateur Page 28