ASROCK IMB-A180-H Manuel du propriétaire

1IMB-A180-HIMB-A180User ManualVersion 1.0Published April 2013Copyright©2013 ASRock INC. All rights reserved.

101.4 I/O Panel1 USB 2.0 Ports (USB01)2 Serial Port (COM1)3 Serial Port (COM2)4 LAN RJ-45 Port (LAN1) (DASH)5 LAN RJ-45 Port (LAN2)6 Front Spea

11Chapter 2: InstallationThis is a Mini-ITX form factor motherboard. Before you install the mother-board, study the conguration of your chassis t

122.1 Installing Memory Modules (DIMM)This motherboard provides two 204-pin DDR3 (Double Data Rate 3) SO-DIMM slots.Step 1. Unlock a DIMM slot by p

132.2 Expansion Slots (PCI Express Slots)There is 1 PCI Express slot and 1 mini PCI Express slot on this mother-board.mini-PCIE Slot: MINI_PCI

14Panel Backlight Power Jumper(3-pin BKT_PWR1)(see p.8, No. 2)Clear CMOS Jumper(3-pin CLRCMOS1)(see p.8, No. 28)LVDS Power (VDDR Power) Jumper(3-pin P

15COM Port Pin9/Power Setting Jumpers(3-pin SET_CM1)(see p.8, No. 5)(3-pin SET_CM2)(see p.8, No. 6)(3-pin SET_CM3)(see p.8, No. 19)(3-pin SET_CM4)(see

162.4 Onboard Headers and ConnectorsOnboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Plac-

17Serial ATA3 Connector (SATA3_1: see p.8, No. 13)Panel Backlight & Audio AMP Volume Control Header (7-pin BLT_VOL1)(see p.8, No. 4)1USB 2.0 Heade

18 1. High Denition Audio supports Jack Sensing, but the panel wire on the chassis must support HDA to function correctly. Please follow the

19System Panel Header(9-pin PANEL1)(see p.8, No. 22)GNDGNDPWRBTN#PLED-PLED+RESET#HDLED-HDLED+1DUMMYThis header accommodatesseveral system front panel

2Copyright Notice:No part of this manual may be reproduced, transcribed, transmitted, or translated in any language, in any form or by any means, exce

20CPU Fan Connector(4-pin CPU_FAN1)(see p.8, No. 9)Though this motherboard provides a 4-Pin CPU fan (Quiet Fan) connector, 3-Pin CPU fans can still wo

21Chassis Intrusion Header This motherboard supports(2-pin CI1: see p.8, No. 14) CASE OPEN detection feature that detects if the chassis c

22Chapter 3: UEFI SETUP UTILITY3.1 IntroductionThis section explains how to use the UEFI SETUP UTILITY to congure your system. The UEFI ch

233.1.2 Navigation KeysUse < > key or < > key to choose among the selections on the menu bar, and use < > key or <

243.2 Main ScreenWhen you enter the UEFI SETUP UTILITY, the Main screen will appear and display the system overview.

253.3 Advanced ScreenIn this section, you may set the congurations for the following items: CPU Configuration, Chipset Configuration, Storage Co

263.3.1 CPU CongurationPSS SupportUse this to enable or disable the generation of ACPI_PPC, _PSS, and _PCT objects.PSTATE AdjustmentUse this to ad

273.3.2 Chipset CongurationDRAM FrequencyIf [Auto] is selected, the motherboard will detect the memory module(s) inserted and assigns a

28Restore on AC/Power LossThis allows you to set the power state after an unexpected AC/power loss. If [Power Off] is selected, the AC/

293.3.3 Storage CongurationOnChip SATA ChannelUse this to enable or disable the onchip SATA channel.OnChip SATA TypeUse this to adjust the onchip SA

3Contents1. Introduction ... 5 1.1 Package Contents ...

303.3.4 Super IO CongurationCOM1 CongurationUse this to set the parameters of COM1.COM2 CongurationUse this to set the parameters of COM2.COM3 Con

313.3.5 ACPI CongurationSuspend to RAMUse this to select whether to auto-detect or disable Suspend-to-RAM. Select [Auto] to enable if the O

323.3.6 USB CongurationUSB 2.0 Controller Use this item to enable or disable the use of USB 2.0 controller.USB 3.0 Controller Use this item to ena

333.3.7 Trusted ComputingSecurity Device SupportEnable to activate Trusted Platform Module (TPM) security for your hard disk drives.

343.4 ToolUEFI Update UtilityInstant FlashInstant Flash is a UEFI ash utility embedded in Flash ROM. This convenient UEFI update tool allows you

353.5 Hardware Health Event Monitoring ScreenThis section allows you to monitor the status of the hardware on your sys-tem, including the parameters

363.6 Boot ScreenThis section displays the available devices on your system for you to con-gure the boot settings and the boot priority.Boot From On

373.7 Security ScreenIn this section you may set or change the supervisor/user password for the system. You may also clear the user password.Secure B

383.8 Exit ScreenSave Changes and ExitWhen you select this option the following message, “Save congu-ration changes and exit setup?” will pop

39Chapter 4: Software Support 4.1 Install Operating System This motherboard supports various Microsoft® Windows® operating systems: 8 / 8 6

41. IntroductionThank you for purchasing ASRock IMB-A180-H / IMB-A180 motherboard, a reliable motherboard produced under ASRock’s consistently

51.2 Specications Platform MB Dimension - Mini-ITX Form Factor: 6.7-in x 6.7-in, 17.0 cm x 17.0 cm CAP - All Solid CAP Fanless - Fan or Fanl

6 Power on Mode - AT/ATX Power on mode supported (setting by jumper) AT: Directly PWR on as Power input ready ATX: Press Button to PWR

7 Display - 1 x D-Sub VGA (IMB-A180) - 1 x HDMI Display - 1 x D-Sub VGA (IMB-A180-H) - 2 x HDMI Audio - 2 x Audio Jack (MIC-in, Line-Out) Enviro

81.3 Motherboard LayoutCOM1VGA1COM2HDMI1*HDMI2RJ-45USB 3.0T: USB2B: USB3RJ-45USB 2.0T: USB4B: USB5Top:FrontSpeak erBotto m:Mic InUSB 2.0T: US B0B: US

91 LVDS Panel Connector*2 Panel Backlight Power Jumper3 Inverter Power/Control Header4 Panel Backlight & Audio AMP Volume Control Header5