ASROCK K7S8XE Manuel d'utilisateur télécharger pdf (Page 12)

2.7 Jumpers Setup

The illustration shows how jumpers are

setup. When the jumper cap is placed on

pins, the jumper is “SHORT”. If no jumper

cap is placed on the pins, the jumper is

“OPEN”. The illustration shows a 3-pin

jumper whose pin1 and pin2 are “SHORT”.

Jumper Setting

FSB_SEL0

(see p.7 item 25)

FSB_SEL1

(see p.7 item 26)

Note:The setting of the CPU front side bus frequency of this motherboard is by

means of the adjustment of jumper-setting. Please follow the figures above

to set the CPU front side bus frequency. Please note that the setting of FSB

200MHz will function only when the installed CPU supports FSB 200MHz.

PS2_USB_PWR1 Short pin2, pin3 to enable

(see p.7 item 22) +5VSB (standby) for PS/2 or

USB wake up events.

Note:To select +5VSB, it requires 2 Amp and higher standby current provided

by power supply.

Clear CMOS

CLRCMOS1 CLRCMOS2

(see p.7 item 17) (see p.7 item 27)

Note:CLRCMOS1 and CLRCMOS2 allow you to clear the data in CMOS. The data in

CMOS includes system setup information such as system password, date,

time, and system setup parameters. There are 2 ways for you to clear and

reset the system parameters to the default setup. Please turn off the com-

puter and unplug the power cord, then you may either short the solder points

on CLRCMOS1 by using metal material, e.g., a paper clip for 3 seconds; or

you may use a jumper cap to short the pin on CLRCMOS2 for 3 seconds.

Please remember to remove the paper clip or the jumper cap after clearing

the CMOS.

FSB 100MHz

2_3

1_2

FSB_SEL0

FSB_SEL1

FSB 133MHz

2_3

FSB_SEL0

FSB_SEL1

2_3

FSB 166MHz

FSB_SEL1

1_2

FSB_SEL0

FSB 200MHz

1_2

2_3

FSB_SEL0

FSB_SEL1

+5V

1_2

+5VSB

2_3

solder points 2-pin jumper

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 26 27

Commentaires sur ces manuels

Pas de commentaire

ASROCK K7S8XE Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Cartes mères ASROCK K7S8XE